Maintenance; General; Daily Cleaning; Cleaning The Toasting Baskets - Hatco Toast King Manuel D'installation Et D'utilisation

MAINTENANCE

General

Hatco Electric Conveyor Toasters are designed for maximum
durability and performance, with minimum maintenance.
NOTE: The conveyor chain gear motor is permanently
lubricated and requires no maintenance.
WARNING
ELECTRIC SHOCK HAzARD:
• Turn OFF power switch, unplug power cord/turn off
power at circuit breaker, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.

Daily Cleaning

To preserve the finish of the toaster, it is recommended that the
metal surfaces be wiped daily with a non-abrasive, damp cloth.
WARNING
Submerging or saturating unit with water will damage the
unit and void unit warranty.
CAUTION
Do not remove toast collector pan or baskets for cleaning
until toaster is cool.
1. Turn the Selector Switch to the OFF (O) position, unplug
power cord/turn off power at circuit breaker, and allow the
unit to cool.
2. Remove and empty the toast collector pan.
3. Wash the toast collector pan with warm water and a mild
detergent. Rinse with water.
4. allow the toast collector pan to air dry before placing back
into the toaster.
5. Wipe the exterior surface of the toaster with a damp cloth.
NOTICE: Use non-abrasive cleaners and cloths only.
6. Wipe dry the entire unit using a dry, non-abrasive cloth.

Cleaning the Toasting Baskets

The toasting baskets need to be removed from the toaster
periodically in order to be cleaned properly.
1. Use the manual advance knob on the right side of the unit
to advance the baskets without energizing the unit.
2. Remove the baskets by pushing the spring-loaded chain
away from the basket while pulling the basket away from
the chain and outward.
• The chain link pins must be pulled out of the toasting
basket holes on the top of each side of the baskets.
Spring-Loaded
Chain
Hold Down
Bar
Removing Toasting Baskets
NOTE: Do not detach the hold down bars when cleaning
toasting baskets.
3. Wipe clean with a soft, damp cloth or soak the baskets in
a mild solution of soap and water.
4. Re-install a basket by aligning a pin on each chain with the
holes in each side of the toasting basket. The pin on the
right-hand chain must be exactly opposite the pin on the
left-hand chain.
5. To attach the remaining baskets, advance the conveyor
and repeat the previous step. Each basket must be hung
immediately below the preceding basket for all baskets to
fit properly.
Misalignment of toasting baskets will cause conveyor to
jam. Hold down bars should be facing out and lying flat on
baskets. Incorrectly positioned bars will cause conveyor to
stop.
10
English
Toasting
Basket
CAUTION
Form No. TRTKm-0816