Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
General
Use the following procedures to operate a Flav-R-Savor Large
Capacity Holding Cabinet.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
Startup
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See
the SPECIFICATIONS section for details.
2. Move the unit Power I/O (on/off) switch to the I (on)
position.
• The digital temperature controller will energize and the
current temperature of the interior of the unit will appear
on the display. CAUTION! Some exterior surfaces
on the unit will get hot. Use caution when touching
these areas.
• The phrase "out 1" will appear in the upper left corner of
the display to show that the unit is in heat mode.
3. Press and release the
temperature will be shown on the display and "out 1" will
flash in the upper left corner.
4. Press the
key or
change the setpoint temperature. If no key is pressed
within 15 seconds, the display will revert to the current
temperature of the cabinet.
5. Press the
key or wait 15 seconds to lock in the new
setpoint temperature. The setpoint temperature range of
the controller is from room temperature to 70°C (158°F).
6. Allow the unit 30 minutes to reach operating temperature
before loading the cabinet with pre-heated food product.
• The current temperature of the interior of the unit will
appear on the display.
Shutdown
1. Move the Power I/O (on/off) switch to the O (off) position.
The display lights and heating system will turn off.
Power I/O (on/off) Switch
Form No. LFSTM-1019
key. The current setpoint
key within 15 seconds to
Control Panel
Locking/Unlocking the Digital Temperature
Controller
The keys on the digital temperature controller can be locked to
prevent unauthorized changes to the settings.
To lock the keys of the digital temperature controller:
• Press and hold both the
same time for over two seconds. The message "Loc" will
appear on the display.
To unlock the keys of the digital temperature controller:
• Press and hold both the
same time until the message "UnL" appears on the display.
Digital Temperature Controller
7
OPERATION
key and
key at the
key and
key at the
Publicité
Chapitres
Table des Matières
Dépannage
