Operation - Hatco SERV-RITE SRB Série Manuel D'installation Et D'utilisation

OPERATION

General
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
ELECTRIC SHOCK HAZARD: Do not fill SRB and SRBW
models with water. They are dry heat units only, not steam
table units.
NOTICE
Do not place anything on top of the glass sneeze guard. It
is not designed to be a weight-bearing component.
Do not slide pans across glass surface, use rough-
bottomed pans, or drop anything on glass surface.
Scratching or breakage may occur. Damage to glass
surface or breakage of glass caused by misuse is not
covered under warranty.
Startup
Glass
Sneeze
Guard
Model SRBW-1
BURN HAZARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
"out 1"
SET
Key
NOTE: The digital temperature controller is pre-set to a setpoint
temperature of 88°C (190°F) at the factory. Once the
setpoint temperature is changed, the new setpoint
temperature will remain in memory until it is changed
again. The Serv-Rite
setpoint temperature of 116°C (240°F).
Removable
Utensil Tray
Overhead
Heat Lamps
Control
Panel
CAUTION
Down Arrow
Key
heated shelf has a maximum
Heated
Glass Shelf
Model SRG-1
Celsius
Symbol
Up Arrow
Key