Operation; General - Hatco FLAV-R-SAVOR PFST Série Manuel D'installation Et D'utilisation

English

General

Use the following procedures to operate the Flav-R-Savor
Holding Cabinet.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
Startup
1. Make sure the unit is plugged into a properly grounded
electrical receptacle of the correct voltage, size, and plug
configuration. See the SPECIFICATIONS section for
details.
2. Move the POWER ON/OFF (I/O) switch to the ON (I)
position.
CAUTION
BURN HAZARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
POWER ON/OFF (I/O) Switch
CABINET TEMPERATURE
Monitor
Form No. PFSTM-0816
3. Set the TEMPERATURE Control to the desired temperature
setting.
Tall
®
NOTE: Temperature settings may vary depending upon product
make-up and consistency. The cabinet temperature
indicator displays the lowest temperature point inside
the cabinet, not the product temperature.
4. Allow the unit 30 minutes to reach operating temperature.
Shutdown
1. Move the Power ON/OFF (I/O) switch to the OFF (O)
position.
2. Allow the unit to cool, and perform the "Daily Cleaning"
procedure in the MAINTENANCE section.
TEMPERATURE
Control
Control Panel
9

OPERATION