Angelo Po FX 82 E3T Manuel D'utilisation Et D'installation page 113

Alarm Fault
Oven door opening or closure
OPE
request
Indicates that cleaning is re -
CLE
quired
The cooking chamber probe
E01
has failed or is not properly con-
nected
The core probe has a failure or
E02
has not been properly connected
The steam discharge probe has
E03
failed
The motor-operated valve is not
E04
positioned correctly
E05 Safety thermostat failure
E06 Overload cutouts tripped
E07 Power board failure
The optional vacuum probe has
E08 failed or is not properly connect-
ed
Electrical component compart-
E10
ment has overheated
E11
Electronic circuit board diag-
E13
nostics tripped
E14
The humidity probe has failed or
E19
is not properly connected
E20 Setup error
English
Remedy
Open or close the oven door
Inform the after-sales service if
this message continues to be
displayed
Launch an automatic cleaning
cycle
Inform the after-sales service
Check the position of the prod-
uct core probe or inform the af-
ter-sales service if it is faulty
Inform the after-sales service
Switch on the oven again and if
the problem persists inform the
after-sales service
Inform the after-sales service
Inform the after-sales service
Inform the after-sales service
Press the "Reset" button
The oven solves the problem on
its own
Inform the after-sales service
Inform the after-sales service
Inform the after-sales service
- 51 -
Notes
The cooking cycle does not start
until the door has been opened
or closed as required
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Cooking cycles with p roduct
core probe cannot be carried
out
Convection and steam cooking
cycles can still be carried out
Convection and steam cooking
cycles can still be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Disconnect and reconnect the
vacuum probe before starting
the cooking cycle.
If the problem persis ts, call the
after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Use and installation manual
IT
GB
DE
FR
ES