Maintenance; Emergency Stop - Agilent Technologies TV 801 Navigator Bolted Flange Notice De Mode D'emploi

16 Instructions for Use

Maintenance

WARNING! The Turbo-V controller must be powered with 3-wire power cord (see
orderable parts table) and plug (internationally approved) for user's safety.
Use this power cord and plug in conjunction with a properly grounded
power socket to avoid electrical shock and to satisfy CE requirements. High
voltage developed in the controller can cause severe injury or death. Before
servicing the unit, disconnect the input power cable.

Emergency Stop

To immediately stop the TV 801 Navigator Bolted Flange in an
emergency condition it is necessary to remove the supply cable from
the mains plug.

Maintenance

The TV 801 Navigator Bolted Flange does not require any
maintenance. Any work performed on the system must be carried out
by authorized personnel.
WARNING! Before carrying out any work on the system, disconnect it from the mains,
vent the pump by opening the appropriate valve, wait until the rotor has
stopped turning and wait until the surface temperature of the pump falls
below 50 °C.
In the case of breakdown, contact your local Agilent service center
who can supply a reconditioned system to replace that broken down.
204/248 TV 801 Navigator Bolted Flange User Manual / 87-900-980-01 (D)