Adjusting Top Burner Primary Air (10 Kw); Greasing The Gas Tap - Angelo Po 191FAE Manuel D'utilisation Et D'installation

ADJUSTING TOP BURNER PRIMARY AIR (10 KW)

To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Remove the screw (D).
5 - Set the burner mount (E) at a distance of
20 mm, and tighten the screw (D).
6 - Replace the control panel (B) and the knobs (A)
on completion of the operation.

GREASING THE GAS TAP

To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Undo the screws (D) and extract the cap (E).
5 - Pull off the cone (F).
6 - Clean the cone (F) and its seat.
7 - Coat the cone with grease (F), fit it in its seat
and turn it a few times.
8 - Pull off the cone (F) to remove the excess
grease.
9 - Replace the cone (F) and the cap (E).
10 - Replace the control panel (B) and the knobs (A)
on completion of the operation.
C
A C B
C
A C B
- 23 -
E
D
IDM-39616601500.tif
E F
D
IDM-39614602300.tif
English
IT
GB
DE
FR
ES