Resetting The Appliance; Lengthy Downtimes Of Appliance - Angelo Po 191FAE Manuel D'utilisation Et D'installation

2 - Turn the knob (B) anti-clockwise (pos. 1) to turn
on the heating elements.
The mains light (D) comes on.
3 - Turn the knob (C) to 1, between the minimum
and maximum temperature, and wait for the
warm-up time before using the oven (See ta-
ble).
The temperature light (E) comes on to indicate
that the oven is not at the working temperature.
The light goes out once the temperature is
reached.
Min
Temperature (°C) 100 135 170 200 235 270
Time in minutes 2'45'' 4'50'' 6'50'' 9'45'' 13'

RESETTING THE APPLIANCE

If the safety thermostat is tripped, the appliance has
to be restored to the initial working conditions as fol-
lows.
1 - Pull off the knob (A).
2 - Undo the screws (C) and remove the control
panel (B).
3 - Press the button (D) of the safety thermostat to
restore the electricity supply.
4 - Replace the control panel (B) and the knobs (A)
on completion of the operation.

LENGTHY DOWNTIMES OF APPLIANCE

If the appliance is to be out of use for a lengthy pe-
riod, proceed as follows.
1 - Turn off the gas supply tap.
2 - Cut off the mains electricity supply using the ap-
pliance's master switch.
3 - Clean the appliance and the surrounding areas
thoroughly.
4 - Turn the knob (B) anti-clockwise (pos. 2-3) to
turn on the top or bottom heating element, de-
pending on the cooking mode required.
Turning off
5 - Turn the knob (B) o setting 4 and the knob (C)
to setting 2, to switch off the heating elements.
The mains (D) and temperature (E) lights go
out.
6 - Turn off the appliance's circuit breaker to dis-
connect it from the electrical mains.
Max
300
16' 18'45''
A C
4 - Spread a film of edible oil over the stainless
steel surfaces.
5 - Carry out all the servicing procedures.
6 - Leave the appliance uncovered and the cook-
ing chambers open.
- 11 -
C D
B
IT
GB
DE
IDM-39616600800.tif
FR
ES
English