Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool.
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Remove the bottom plate (C) and the grid (D)
from the oven and clean them thoroughly.
4 - Clean the inside parts of the oven to remove
any deposits which may impair its operation.
5 - Dry the surfaces and reassemble the compo-
nents.
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the con-
trol panel (B).
4 - Undo the screw (D) of the pressure con-
nection.
5 - Connect the pressure gauge (E) to the
pressure test point (F).
6 - Turn the gas supply tap back on.
7 - Light all the burners and turn the knobs to the
IT
IT
full flame setting (see page pag. 10), then
check that the pressure reading complies with
GB
GB
the values provided in the table at the back of
the manual.
DE
DE
8 - Turn off the burners, disconnect the pressure
gauge and return all components to their initial
condition on completion of the operation.
FR
FR
ES
ES
The appliance has been tested before being put
into service. The information provided below is in-
tended to assist in the identification and correction
of any anomalies and malfunctions which might oc-
cur during use. The user can solve some of these
English
CLEANING OVEN
CHECKING GAS PRESSURE
TROUBLESHOOTING
D
C
A C

FAULT

problems himself, but for others specific technical
knowledge or skill is required, and so they must
only be carried out by qualified staff with recognised
experience acquired in the specific sector of opera-
tion.
- 14 -
C
E
B
IDM-39616601000.tif
F
D
IDM-39614601100.tif
6

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

191faae

Table des Matières