Electrical Connection - Angelo Po 191FAE Manuel D'utilisation Et D'installation

ELECTRICAL CONNECTION

Important
The connection must be made by author-
ised, skilled personnel, in accordance with
the relevant legal requirements, using ap-
propriate and specified materials.
The appliance is supplied with operating
voltage 400V/3N (230V/3 available on re-
quest).
Specify the correct voltage for your device;
it cannot be modified after purchase.
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
1 - If not already present, install a circuit-
breaker (A) with overload cutout and dif-
ferential safety breaker close to the appli-
ance.
2 - Pull off the knob (B).
3 - Undo the screws (C) and remove the control
panel (D).
4 - Undo the screws (E) to remove the lid (F).
5 - Connect the circuit-breaker (A) to the terminal
board (G) of the appliance as shown in the dia-
IT
gram and in the electrical system diagram at
the back of the manual.
GB
Use a flexible cable with at least type H07RN-F
characteristics, rated for an operating tempera-
DE
ture of at least 80°C.
6 - Tighten the cable gland (H).
FR
Important
When connecting, take care to connect the
ES
neutral and earth lines.
7 - Fit the lid (F) and secure it with the screws (E).
8 - Replace the control panel (D) and the knobs (B)
on completion of the operation.
English
E
G
H
- 20 -
A C
B C D
IDM-396166012000.tif
IDM-39616601300.tif
E
F