Ducati 749R Manuel D'utilisation Et Entretien page 162

Notes
It is not necessary to disconnect the main wiring
harness cable from the headlamp body to replace the
headlamp bulbs.
Notes
Be careful to hold the new bulb at the base only.
Never touch the transparent body with your fingers;
this could darken it and thus reduce the brightness.
Refitting
After replacing a burnt-out bulb, re-connect the instrument
panel to the main wiring harness and place the instrument
panel in the rubber retaining elements.
Refit the bottom cover and headlamp fairing, and secure
them with the fastening screws. Check that the turn signal
indicator wires are correctly routed in the grooves in the
headlamp fairing brackets.
5
5
5
E
4
5
fig. 68
69