Connecting The Pressure Washer To The Power; Supply; Switching The Pressure Washer On And Off; Switching On The Pressure Washer - Stihl RE 95 Notice D'emploi

9 Connecting the pressure washer to the power supply
2
► Unscrew connector (1).
► Screw water filter (2) onto connector (3) and tighten hand-
tight.
Connecting the water hose
1
4
► Fill water hose (1) with water until there is no air left in the
water hose.
► Screw coupling (2) onto connector (3) of water filter and
tighten hand-tight.
► Suspend the suction cup (4) in the water source so that
the suction cup (4) does not touch the bottom.
► If the spray gun is attached to the high-pressure hose:
remove the spray gun.
► Hold the high-pressure hose downward.
► Switch on pressure washer and run it until an even jet of
water is delivered by the high-pressure hose.
► Switch off pressure washer.
0458-815-9621-A
3
1
2
1
3
► Attach spray gun to the high-pressure hose.
► Squeeze and hold down spray gun trigger.
► Switch on pressure washer.
9 Connecting the pressure washer to the
power supply
9.1

Connecting the pressure washer to the power

supply

3
2
3
► Move the rocker switch (1) to the 0 position.
► Remove connecting cord (2) from the holders (3).
► Plug the connecting cord (2) into a correctly installed
socket.
10 Switching the pressure washer on and
off

10.1 Switching on the pressure washer.

When the pressure washer is switched on, voltage
fluctuations may occur under unfavorable mains conditions
with a power line impedance greater than 0.15 Ohm. The
voltage fluctuations may negatively affect other connected
electrical appliances.
English
1
55