Connecting To A Water Source; Connecting The Water Filter; Connecting The Pressure Washer To The Water; Supply - Stihl RE 95 Notice D'emploi

8 Connecting to a water source

7.5.2 Removing the nozzle
1
► Press and hold the safety latch (1).
► Pull out the nozzle (2).
8 Connecting to a water source
8.1

Connecting the water filter

If the pressure washer is to be operated with sandy water or
with water from cisterns, a water filter must be connected in-
line between the water tap and the water hose. The water
filter filters sand and dirt out of the water and thus protects
the components of the pressure washer from damage.
Depending on the market, the water filter may be supplied
with the pressure washer.
0458-815-9621-A
2
2
1
► Unscrew connector (1) from water tap (2).
► Screw water filter (3) onto water tap (2) and tighten hand-
tight.
► Screw connector (1) onto water filter (3) and tighten hand-
tight.
► Push hose coupling (4) of water hose (5) onto
connector (1).
8.2

Connecting the pressure washer to the water

supply

Connecting the water hose
The water hose must meet the following requirements:
– The water hose has a diameter of 1/2".
– The water hose is between 10 m and 25 m long.
► Connect water hose to a water tap.
► Turn on the water tap fully and flush the water hose with
water.
Sand and dirt will be flushed out of the water hose. The
water hose will be vented.
► Turn off water tap.
English
2
3
1
4
5
53