Connecting The Pressure Washer To Another Water - Stihl RE 90 Notice D'emploi

English
Disconnecting the Water Hose
To disconnect the water hose:
► Switch off the pressure washer, @ 10.2.
► Disconnect the pressure washer from the power supply.
► Shut off the water supply.
► Pull the spray gun trigger to relieve pressure.
► Lock the spray gun trigger.
1
4
► Remove the water hose (4) from the coupling (1) onto the
pressure washer or water filter (2).
9.2 Connecting the pressure washer to another
water source
WARNING
Make sure the pressure washer is switched off and
disconnected from the power supply before connecting to or
disconnecting from another water source.
The pressure washer can draw water from water butts and
cisterns and from running or stagnant bodies of water.
22
2
1
4
So that the water can be drawn in, the height difference
between the pressure washer and the water source should
not exceed the maximum suction lift (a), @ 18.1.
The appropriate STIHL suction set must be used. The
suction set includes a water hose with a special coupling.
Depending on the market, the appropriate STIHL suction set
may be supplied with the pressure washer.
Connecting the water filter
If operating the pressure washer with sandy water from
water butts, cisterns or running or stagnant bodies of water,
a water filter must be connected in-line between the water
hose and the pressure washer.
To connect the water filter:
1
2
► Unscrew the coupling (1).
► Screw the water filter (2) onto the connector (3) and
tighten by hand.
9 Connecting the Water Supply
a
3
0458-002-8221-A