Connecting The Pressure Washer To The Power; Connecting The High-Pressure Washer To An; Electric Power Supply - Stihl RE 80 Notice D'emploi

English
Connecting the water filter
If the high-pressure washer is operated with water
containing sand from water butts, cisterns or from flowing or
still rivers and lakes, a water filter must be connected to the
high-pressure washer.
Depending on the market, the water filter may be included
with the high-pressure washer.
1
► Unscrew the connector (1).
► Screw the water filter (2) onto the water supply and tighten
by hand.
Connecting the water hose
3
2
► Fill the water hose (1) with water so that no air is present
in the water hose any more.
► Screw the coupling (2) onto the connector of the water
filter (3) and tighten by hand.
58
2
1
4
1
9 Connecting the pressure washer to the power supply
► Attach the suction cup (4) to the water source so that the
suction cup (4) does not touch the ground.
► If the spray gun is fitted to the high-pressure hose:
Remove the spray gun.
► Hold the high-pressure hose downwards.
► Switch on the high-pressure washer until an even water jet
flows out of the high-pressure hose.
NOTICE
If the high-pressure washer does not suck in water, the
pump may run dry and the high-pressure washer may be
damaged.
► If no water escapes from the high-pressure hose after two
minutes: Switch off the high-pressure washer and check
the water supply.
► Switch off the high-pressure washer.
► Connect the spray gun to the high-pressure hose.
► Press and hold down the spray gun trigger.
► Switch on high-pressure washer.
9 Connecting the pressure washer to the
power supply
9.1

Connecting the High-Pressure Washer to an

Electric Power Supply

1
► Move the rocker switch (1) to the 0 position.
2
3
4
0458-001-9621-A