Connecting The Water Supply; Connecting The Pressure Washer To The Mains; Water Supply - Stihl RE 130 PLUS Notice D'emploi

Masquer les pouces Voir aussi pour RE 130 PLUS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9 Connecting the Water Supply

► If the high pressure nozzle is difficult to insert into the
spray lance, apply a food-safe fitting grease to the sealing
surface on spray lance.
8.4.2
Removing the Spray Nozzle
WARNING
To reduce the risk of severe injury from unintended
spraying, switch off the pressure washer, relieve system
pressure and lock the spray gun trigger before attempting to
adjust or change a spray nozzle or other accessory.
To remove the spray nozzle:
► Switch off the pressure washer, @ 10.2.
► Pull the spray gun trigger to relieve pressure.
► Lock the spray gun trigger.
2
► Press the high pressure nozzle (1) against the spray
lance (2) and pull out the nozzle(1).
9 Connecting the Water Supply
9.1

Connecting the Pressure Washer to the Mains

Water Supply

WARNING
Make sure the pressure washer is switched off and
disconnected from the power supply before connecting to or
disconnecting from the mains water supply.
0458-836-8221-A
1
Connecting the water filter
If the pressure washer is to be operated with sandy water or
with water from cisterns, a water filter must be connected in-
line between the water hose and the pressure washer. The
water filter filters sand and dirt out of the water and thus
protects the components of the pressure washer from
damage.
To connect the water filter:
► Unscrew the coupling (1).
► Screw the water filter (2) onto the connector (3) and
tighten by hand.
► Screw the coupling (1) onto the water filter (2) and tighten
by hand.
Connecting the Water Hose
The water supply must meet the following requirements:
– Minimum length of water hose: 30 ft. (10 m)
– Maximum water inlet pressure: 145 psi (1 MPa / 10 bar)
To connect the pressure washer to the mains water supply:
► Switch off the pressure washer, @ 10.2.
► Disconnect the pressure washer from the power supply.
► Remove all sand and debris from the connections and
couplings.
► Connect the water hose to the water supply.
► Fully open the tap to flush any sand or dirt from the hose.
English
3
2
1
19

Publicité

Chapitres

Table des Matières
loading

Table des Matières