Tilt Up And Down - TOHATSU MFS 6BZ Manuel De L'utilisateur

4. Change the trim lock pin position as
following picture.
2 3
1. Preset knob
2. Pull
3. Higher
4. Lower
5. Reinstall preset knob securely.
6. Gentry lower the outboard.
Trim angle adjustment (Power tilt
type)
The transom angle adjustment
1. Stop the engine
2. Operate the Power Tilt switch and
raise the outboard motor to the tilt up
position.
3. Lock the tilt with the Tilt stopper.
4. Change the trim lock pin position as
following picture.
1
1
2
4
ENOF01425-0
2 2
3
ENOF01426-0
ENGINE OPERATION
1. Trim lock pin
2. Higher
3. Lower
5. Reinstall the tilt lock pin securely.
6. Operate the Power Tilt switch and
lower the outboard.
ENOM00060-A

8. Tilt up and down

ENOW00055-0
WARNING
Do not tilt up or down outboard motor
when swimmer(s) or passenger is near to
prevent them from being caught between
outboard motor body and clamp bracket in
case the outboard motor body falls.
ENOW00048-0
WARNING
When tilting up or down, be careful not to
p l a c e y o u r h a n d b e t w e e n t h e s w i v e l
bracket and the stern bracket.
Be sure to tilt the outboard motor down
slowly.
ENOW00056-A
WARNING
When tilting up outboard motor with fuel
joint for over a few minutes, be sure to dis-
connect fuel hose, or fuel may leak, poten-
tially catching fire.
ENOW00057-0
CAUTION
Do not tilt up outboard motor while engine
operates, or no cooling water may be fed,
leading to engine seizure due to overheat-
ing.
49
7