Tilt Up And Down - TOHATSU MFS 4C Manuel De L'utilisateur

ENOM00054-0
Improper trim angle (bow dips into the
water)
Set the thrust rod (or priset knob) higher if
the bow of the boat is below horizontal.
1. Trim angle adjustment hole
2. Thrust rod
3. Higher
4. Lower
Trim angle adjustment (Manual tilt
type)
The transom angle adjustment
1. Stop the engine.
2. Shift into neutral.
ENOF00052-0
ENOF00053-0
1
2
4
3
ENOF00440-0
ENGINE OPERATION
3. Raise the outboard motor to the tilt up
position.
4. Change the thrust rod position as fol-
lowing picture.
3
2
1. Push in
2. Rise the stopper
3. Pull out
5. Reinstall the thurst rod securely.
6. Gentry lower the outboard.
ENOM00060-A

8. Tilt up and down

ENOW00055-0
WARNING
Do not tilt up or down outboard motor
when swimmer(s) or passenger is near to
prevent them from being caught between
outboard motor body and clamp bracket in
case the outboard motor body falls.
ENOW00048-0
WARNING
When tilting up or down, be careful not to
p l a c e y o u r h a n d b e t w e e n t h e s w i v e l
bracket and the stern bracket.
Be sure to tilt the outboard motor down
slowly.
39
1
ENOF01238-0
7