Self-Monitoring Functions Overview; Errors During Data Input; Code Error; No Contact - Hürner HST 300 Pricon 2.0 Manuel Utilisateur

"Geo-data on" means that the geographic coodinates
have to be recorded after every welding (see Sect. 6.7
for details), "off," that this is not possible.
"Installing Company on" means that the company that
performs the installation work has to be entered before
every welding, "off," that this is not possible.
"Print Tags – M – " means that by pressing the MENU key,
the user can access a sub-menu for starting to print (a)
label(s) with reference to a given welding operation,
with the optional label tag printer.
All data can also be read from a bar code with the
scanner, provided such a bar code is available.
Info
11

Self-Monitoring Functions Overview

11.1 Errors During Data Input

11.1.1 Code Error

An erroneous input has occurred, a code tag is poor or has
an error in code symbology or code reading was improper.

11.1.2 No Contact

There is no properly established electric contact between
the welding unit and the fitting (check push-on terminal
on fitting), or the heater coil is defective.

11.1.3 Low Voltage

The input voltage is below 175 volts. Adjust generator
output voltage.

11.1.4 Overvoltage

The input voltage is over 290 volts. Decrease generator
output voltage.

11.1.5 Overheated

The welding unit temperature is too hot. Let it cool down
for about 1 hour, while making sure to leave it switched
on, so the internal fan runs to help cool it down.

11.1.6 System Error

CAUTION!
The welding unit has to be disconnected immediately from
both the power supply and the fitting. The auto-test has
detected an error in the system. The unit must no longer
24
EN
HÜRNER HST 300 Pricon 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Version January 2018