Selecting The Temperature Unit And Entering The Inventory Number; Understanding The "Recording" Sub-Menu; Self-Monitoring Functions Overview; Errors During Data Input - Hürner HCU 300 mini Manuel Utilisateur

using the ï, ð arrow keys (from 0 to 100) and confirm your setting
by pressing the START/SET key.

10.1.4 Selecting the Temperature Unit and Entering the Inventory Number

The unit of temperature values (Centigrade or Fahrenheit) can
be selected in a sub-menu similar to the language selection (see
Sect. 10.1.1). The internal identifier of the welding unit in its owner's
inventory can be entered in the same way as the commission number
(see Sect. 6.2).

10.2 Understanding the "Recording" Sub-menu

"Welder Code on" means that the welder identification code has to
be entered as set with "Welder Code Options," "off," that this
is impossible.
"Commission Number on" means that the commission number (job
number) will have to be entered or confirmed before every new
welding, "off" that the user is not prompted to enter it.
"Additional Data on" means that the additional data will have to be
entered or confirmed before every new welding, "off" that the
user is not prompted to enter them.
"Fitting Code on" means that the second, so-called traceability code
of the electrofusion fitting has to be entered before every weld-
ing, "off," that this is not possible.
"Installing Company on" means that the company that performs the
installation work has to be entered before every welding, "off,"
that this is not possible.
"Print Tags – M – " means that by pressing the MENU key, the user
can access a sub-menu for starting to print (a) label(s) with refer-
ence to a given welding operation, with the optional label tag
printer.
All data can also be read from a bar code with the scanner,
provided such a bar code is available.
Info
11

Self-Monitoring Functions Overview

11.1 Errors During Data Input

11.1.1 Code Error

An erroneous input has occurred, a code tag is poor or has an error
in code symbology or code reading was improper.

11.1.2 No Contact

There is no properly established electric contact between the welding
unit and the fitting (check push-on terminal on fitting), or the heater
coil is defective.

11.1.3 Low Voltage

The input voltage is below 175 volts. Adjust generator output volt-
age.

11.1.4 Overvoltage

The input voltage is over 290 volts. Decrease generator output volt-
age.
16
EN
HÜRNER HCU 300 mini User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Data Recording
Welder Code
>Commission No.
Additional Data on
Version November 2015
on
on
Display 19