Programming; Tools - LEGRAND Megaline Rack Mode D'emploi Pour L'utilisateur

4.7

Programming

Planning Schedule
Enable
ð
View/Edit
Sched. sequence
Reset
Restart
ð
Delay
Min. autonomy
Shutdown
ð
Delay
4.8

Tools

Segnalling Test
ð
LCD Display Test
Battery Test
Battery Calibration
Enable
To enable or disable set programmes
To set and modify programmes. The following functions
are available:
- Batteries Test (verifies the status of the batteries)
- Batt. Calibration (calibration of the batteries)
- Turn on (to switch the UPS on)
- Turn off (to switch the UPS off )
- Absent (disables programming)
View/Edit
Each programme can be executed in the following ways:
- Daily "hour-minutes": executed every day at the
set hour-minutes;
- Single "day –month –hour -minutes":
executed once on the set "day –month –hour -minutes"
- Weekly "day name –hour -minutes" :
executed every week on the set "day name –hour-minutes".
Used to display all the set programmes
Sched. sequence
in the daily order (max 16)
Reset Deletes all settings
Duration, in seconds, of the warning signal
Delay
that the UPS is about to switch back on
Percentage of battery charge below which the UPS will not
Min. Autonomy
automatically switch back on
Duration, in seconds, of the warning signal
Delay
that the UPS is about to switch back on
Tests the warning lights. Press the ENTER button
Segnalling Test
to execute the test of the Green, Yellow and Red warning
lights and the Acoustic warning signal.
Tests the alphanumeric display.
LCD Display Test
Press the ENTER button and all the available digits are
shown on the alphanumeric display.
Tests the batteries. Contact your Service Centre
Battery Test
in case of problems.
Calibrates the batteries, calculating the discharge
curve for the batteries. We recommend this cycle be
Battery
carried out when the batteries have been changed
Calibration
so that the UPS is able to provide precise information
regarding the status of their charge.
Megaline Rack
47