Connection Of The Control Cables Between Master And Slave - Lenze 9300 vector Instructions De Montage

5 Electrical installation
Master and slave connection

Connection of the control cables between master and slave

5.2.4 Connection of the control cables between master and slave
0
2
4
Fig. 5−4
How to connect the control cables
1. Installation and connection of the ribbon cable 0:
By default the ribbon cable is inside the master. The plug 2 is already attached to the
Drive Board.
– Route the ribbon cable from the master to the Drive Board connection in the slave,
inserting the ribbon cable into the cable ducts 1.
– Plug the ribbon cable plug 0 into the socket 3 at the Drive Board.
2. Laying and connecting 2−core cables with plugs 4:
By default the cable is inside the master. The corresponding cable with socket is in the
slave.
– Lay the two−core cable from the master to the socket in the slave.
– Connect the 2−pole plug with the 2−pole socket in the slave.
3. Laying and connecting 10−core cables with plugs 5:
By default the cable is inside the master. The corresponding cable with socket is in the
slave.
– Lay the two−core cable from the master to the socket in the slave.
– Connect the 10−pole plug with the 10−pole socket in the slave.
84
1
DC-
5
Connection of the control cables between master and slave
l
0
DC+
0
1
1
3
9300VEC028
EDKVF9383 DE/EN/FR 4.0