Dubbing Selected Scenes From A Tape; Digital Program Editing - Sony Handycam DCR-PC330E Mode D'emploi

Dubbing selected
scenes from a tape

– Digital program editing

You can select up to 20 scenes (programs)
and record them in the desired order to other
recording device such as VCRs or to a
"Memory Stick" inserted in your camcorder.
When you are recording on a "Memory
Stick," skip steps 1 and 2 and start from
"Recording the selected scenes as programs"
(p. 95).
Delete unwanted scene
Change the order
Results of editing
Step 1 : Preparing your
camcorder and VCR for operation
Follow the steps below when you are
performing a digital program edit for the first
time to a tape in a VCR. You can skip this
setting if you have set up the VCR by the
following procedure before.
b Notes
• You cannot perform the Digital program editing on
a VCR that does not support [IR SETUP] codes.
• The operating signal for the Digital program editing
cannot be transferred via the LANC jack.
1
Connect your VCR to the camcorder
as a recording device (p. 86).
You can use either the A/V connecting
cable or the i.LINK cable to make the
connection. The dubbing procedure is
easier with the i.LINK connection.
2
Prepare your VCR.
• Insert a cassette for recording.
• Set the input selector to input mode if your
VCR has one.
3
Prepare your camcorder (playing
device).
• Insert a cassette for editing.
• Slide the POWER switch to select the
PLAY/EDIT mode.
4
Touch .
5
Touch [MENU].
6
Touch / to select
PLAY), then touch
7
Touch / to select [PROG.
EDIT], then touch
(EDIT/
.
.
,continued
91
Dubbing/Editing