Cassette Tapes - Sony Handycam DCR-PC330E Mode D'emploi

Batteries/Power sources
Symptom
The CHG (charge) lamp does not
light while the battery pack is being
charged.
The CHG (charge) lamp flashes while
the battery pack is being charged.
The battery pack is quickly
discharged.
The remaining battery time indicator
does not indicate the correct time.
The power turns off frequently
although the remaining battery
indicator indicates that the battery
pack has enough power to operate.
The power abruptly turns off.
A problem occurs when the
camcorder is connected to the AC
Adaptor.

Cassette tapes

Symptom
Cassette cannot be ejected from the
compartment.
Cassette is not ejected even when the
cassette lid is open.
104
Troubleshooting
Cause and/or Corrective Actions
cAttach the battery pack to the camcorder correctly. If the lamp still does
not light up, then it indicates that no power is supplied from the wall
socket.
• The battery charge is completed. (p. 13)
cAttach the battery pack to the camcorder correctly. If the problem
persists, disconnect the AC Adaptor from the wall socket and contact
your Sony dealer. The battery pack may be damaged. (p. 13)
• The temperature of the environment is too low, or the battery pack has
not been charged enough. This is not a malfunction.
cFully charge the battery again. If the problem persists, replace the
battery pack with a new one. It may be damaged. (p. 13, 119)
• The temperature of the environment is too high or too low, or the battery
pack has not been charged enough. This is not a malfunction.
cFully charge the battery again. If the problem persists, replace the
battery pack with a new one. It may be damaged. (p. 13, 120)
• A problem has occurred in the remaining battery time indicator, or the
battery pack has not been charged enough.
cFully charge the battery again to correct the indication. (p. 13)
• [A.SHUT OFF] in the
(p. 81)
cWhen approximately 5 minutes have elapsed while you do not operate
your camcorder, the camcorder is automatically turned off.
Slide the POWER switch down to turn the power on again. (p. 16) Or
use the AC Adaptor.
cTurn off the power, and disconnect the AC Adaptor from the wall socket.
Then, connect it again.
Cause and/or Corrective Actions
cMake sure the power source (battery pack or AC Adaptor) is connected
correctly. (p. 13)
cRemove the battery pack from the camcorder, then attach it again. (p. 13)
cAttach a charged battery pack to the camcorder. (p. 13)
cMoisture condensation is starting in your camcorder. (p. 122)
(STANDARD SET) menu is set to [5 min].