Refueling The Tiller; Adjusting The Tiller For The User - Stihl MH 600 Notice D'emploi

English
► Add the engine oil as described in the engine
instruction manual.
6.10 Filling the Oil Bath Air Filter
The oil bath air filter filters the air taken in by the
engine.
NOTICE
■ The oil bath air filter does not contain any
engine oil on delivery. Starting the engine with
no or too little engine oil in the oil bath air filter
may damage the tiller.
► Always check the engine oil level in the oil
bath air filter before starting and if neces‐
sary top up.
The engine oil specification and capacity can be
found in the engine instruction manual.
7

Refueling the Tiller

7.1 Refuelling the Tiller
NOTICE
■ The tiller may be damaged if the correct fuel is
not used.
► Observe the specifications in the engine
instruction manual.
► Stop the engine.
► Place the tiller on a level surface.
► Open the cover.
► Clean the area around the fuel tank cap with a
damp cloth.
► Turn the fuel tank cap anti-clockwise until it
can be removed.
► Remove the fuel tank cap.
► Add fuel without spilling any and stop at least
15 mm short of the fuel tank brim.
► Place the fuel tank cap on the fuel tank.
► Turn the fuel tank cap clockwise and hand
tighten.
The fuel tank is sealed.
36
8 Adjusting the Tiller for the
User
8.1 Adjusting the Handlebar Height
The handlebar can be adjusted to five different
height settings.
► Stop the engine.
► Place the tiller on a level surface.
► Hold handlebar (1) with one hand on han‐
dle (2).
► Press lever (3) downwards with the other hand
and hold.
► Move handlebar (1) into the desired position.
► Release lever (3).
The handlebar is engaged.
8.2 Adjusting the Handlebar Later‐
ally
The handlebar can be adjusted laterally to three
positions.
► Stop the engine.
► Place the tiller on a level surface.
7 Refueling the Tiller
0478-404-9607-B