Topping Up The Engine Oil; Filling The Oil Bath Air Filter; Refueling The Tiller; Adjusting The Tiller For The User - Stihl MH 610 Notice D'emploi

English
NOTICE
■ The tiller does not contain any gearbox oil on
delivery. Starting the engine with no or too lit‐
tle gearbox oil may damage the tiller.
► Check the gearbox oil level before starting
and if necessary top up.
► Stop the engine.
► Place the tiller on a level surface.
► Clean the area around the gearbox oil cap
with a damp cloth.
► Turn the gearbox oil cap anti-clockwise until it
can be removed.
► Remove the gearbox oil cap.
► Add 1.25 l of SAE10W30 gearbox oil without
spilling any.
► Place the gearbox oil cap on the filler neck.
► Turn the gearbox oil cap clockwise and hand
tighten.
The filler neck is sealed.
6.9

Topping Up the Engine Oil

The engine oil lubricates and cools the engine.
The engine oil specification and capacity can be
found in the engine instruction manual.
NOTICE
■ The tiller does not contain any engine oil on
delivery. Starting the engine with no or too lit‐
tle engine oil may damage the tiller.
► Always check the engine oil level before
starting and if necessary top up.
► Add the engine oil as described in the engine
instruction manual.
6.10

Filling the Oil Bath Air Filter

The oil bath air filter filters the air taken in by the
engine.
12
NOTICE
■ The oil bath air filter does not contain any
engine oil on delivery. Starting the engine with
no or too little engine oil in the oil bath air filter
may damage the tiller.
► Always check the engine oil level in the oil
bath air filter before starting and if neces‐
sary top up.
The engine oil specification and capacity can be
found in the engine instruction manual.
7

Refueling the Tiller

7.1 Refueling the Tiller
NOTICE
■ The tiller may be damaged if the correct fuel is
not used.
► Observe the specifications in the engine
instruction manual.
► Stop the engine.
► Place the tiller on a level surface.
► Open the cover.
► Clean the area around the fuel tank cap with a
damp cloth.
► Turn the fuel tank cap anti-clockwise until it
can be removed.
► Remove the fuel tank cap.
► Add fuel without spilling any and stop at least
15 mm short of the fuel tank brim.
► Place the fuel tank cap on the fuel tank.
► Turn the fuel tank cap clockwise and hand
tighten.
The fuel tank is sealed.
8 Adjusting the Tiller for the
User
8.1

Adjusting the Handlebar Height

The handlebar can be adjusted to five different
height settings.
► Stop the engine.
► Place the tiller on a level surface.
7 Refueling the Tiller
0478-404-9902-B