Maintenance And Use; Computer - PowerPeak Home Trainer Ergometer Mode D'emploi

MAINTENANCE AND USE
• This device requires a regular check‐up to prevent physical injury. This means that bolts and nuts
should be frequently checked for cracks and sharp edges etc.
• Defective components must be replaced immediately. If this is not possible, the device must be put
out of order until the necessary repairs have been made.
• Clean only with a damp cloth, do not use solvent cleaners.
• This product is intended for use in clean, dry conditions. You should avoid storage in excessively cold
or damp places as this may lead to corrosion and other related problems.
COMPUTER
Turn computer on
Once the 6‐volt adaptor is connected, the computer switches on and a tone sounds.
Attention: if the computer does not receive a signal for more than 4 minutes, the computer will
automatically switch to sleeping mode. Press a key or move the pedals to start the computer.
Keys
‐:
+:
ST/STOP (start/stop):
RECOVERY:
ENTER:
RESET:
TTL/RESET (total reset): Reset all values to '0'.
1. Select a function.
2. Set the value of a function.
1. Select a function.
2. Set the value of a function.
Start or terminate a program.
Measuring your fitness level.
1. Confirm a selected function.
2. Confirm the set value.
Reset the value of a certain function to '0'.
27