Maintenance And Use - PowerPeak FHT6704 Mode D'emploi

Step 6: assembling computer
Connect the sensor A3&A4 as shown in FIG.6, then
Install the computer (17) into the support tube of the
main frame with the bolt (11).
NOTE: The pulse wire of computer must connect the
wire of the handlebar.
Step 7: Connect the power supply
Last but not least, connect the adapter (30) to the adapter
input at the lower backside of the chain cover (you will find
a marking: ("Adapter input")

MAINTENANCE AND USE


This device requires a regular check-up to prevent
physical injury. This means that bolts and nuts should be frequently checked for cracks and sharp
edges etc.

Defective components must be replaced immediately. If this is not possible, the device must be
put out of order until the necessary repairs have been made.

Clean only with a damp cloth, do not use solvent cleaners.

This product is intended for use in clean, dry conditions. You should avoid storage in excessively
cold or damp places as this may lead to corrosion and other related problems.