Maintenance And Use - PowerPeak HOME TRAINER Mode D'emploi

MAINTENANCE AND USE


This device requires a regular check-up to prevent physical injury. This means that bolts and nuts
should be frequently checked for cracks and sharp edges etc.

Defective components must be replaced immediately. If this is not possible, the device must be
put out of order until the necessary repairs have been made.

Clean only with a damp cloth, do not use solvent cleaners.

This product is intended for use in clean, dry conditions. You should avoid storage in excessively
cold or damp places as this may lead to corrosion and other related problems.
COMPUTER
Turn computer on and off
The monitor uses two 1.5V "AA" batteries. This system turns on when any key is pressed or when it
receives an signal input from the speed sensor.
If the computer does not receive a signal for more than 4 minutes, the computer will automatically
switch to sleeping mode. Press a key or move the pedals to start the computer.
Attention: If there is an improper display on the monitor, please replace the batteries. Please take
care to remove all batteries at the same time.
Reset
To computer can be reset by either changing the battery or pressing the mode key for 3 seconds.
Mode key
Press the MODE key to choose SCAN or LOCK. If you do not want the scan mode, press the MODE key
if the function you want starts to blink. On overview of the functions is shown below.
Select function
TIME: Press the MODE key until the pointer locks on to time. The total working time will be shown
after the exercise is started.