How To Connect The Outputs Of The Controller; J2 - Serial - Agilent Technologies SpecialTurbo-V 1K-G Mode D'emploi

17 Technical Information
J1 - In-Out

How to Connect the Outputs of the Controller

The following figure shows a typical logic output connection (relay
coil) but any other device may be connected e.g. a LED, a computer,
etc., and the related simplified circuit of the controller. The figure
example refers to the programmable set point signal on pins 11 and
9.
Figure 17
J2 – Serial
Figure 18
This is a 9 pin D-type serial input/output connector to control via an
RS 232 or RS 485 connection the Special Turbo-V 1K-G.
260/294
Typical output connection
Special Turbo-V 1K-G User Manual / 87-901-006-01 (B)