How To Use By Front Panel - Agilent Technologies TwisTorr 74FS AG Rack Mode D'emploi

17 Technical Information

How to Use by Front Panel

How to Use by Front Panel
Figure 29

The front panel START/STOP function is available only if the controller is set to
NOTE
"FRONT mode". If it is set to "REMOTE mode", when the key is pressed an error
message is shown indicating "COMMAND LOCKED IN REMOTE", if it is set to
"SERIAL" mode, the "COMMAND LOCKED IN SERIAL MODE" error message is
displayed.
The "Reset Fail" function is always available regardless of controller mode.
248/300
Start Stop and Reset Fail button
Press once for the START command and again for the STOP
command. In the case of controller's failure, press once to
reset the fail condition.
TwisTorr 74 FS AG Rack Controller User Manual / 87-901-055-01