Güde GSS 500 Traduction Du Mode D'emploi D'origine page 22

Fig. 11
Fig. 12
Operator Safety Instructions
Unplug the unit before any maintenance/adjustment and repair. Unplug after finishing the work as well.
•
Do not use the unit before you have read the operating manual carefully.
•
Observe all the safety instructions indicated in the manual.
•
Be responsible to the others.
Step by Step Instructions
•
Turn the slide with a clamping hole to the required position according to the saw disc diameter. .
•
Choose a suitable clamping adaptor and fix the disc in place.
•
Set up the slide so that it is not possible to sharpen the disc mistakenly when there is a hit on the horizontal hole.
•
Mark the teeth internal surfaces with a black pen and put the grinding wheel in the standstill on the area to be ground.
•
Switch the sharpening machine and scrape the surface marked in black off to enable additional calibration.
•
Grind very carefully, according to the saw disc diameter, one tooth after another.
•
When grinding of all inner teeth areas are finished, grind evenly the teeth slopes on the inclined area of the disc using a stop to
provide for eccentric run of the disc.
•
Clean the unit carefully.
Troubles-Causes- Troubleshooting
Trouble Cause
1.
Burning disc (blunt)
2.
The sharpening surface excessively
lubricated.
Worn diamond layer.
Set up the pre-adjusted angle in reverse direction. It is possible
to sharpen the remaining teeth now.
Tip: Use a selector pen.
If grinding small saw discs, it helps to remove supporting
screws. That should be found out individually according to the
saw disc and cutting edge geometry.
Troubleshooting
1. Clean the unit with the sharpening tool.
2. Replace the disc