Güde GSS 500 Traduction Du Mode D'emploi D'origine page 18

Technical Data
Power connection
Frequency/Protection type
Protection class:
Max. output P
1
Motor speed
Approximate Grinding wheel diameter:
Grinding wheel setting angle
Supporting bench setting angle :
Saw disc clamping adapter :
Connection cable:
Approximate weight
Dimension L x W x H (mm):
Ordering No. .:
Transportation and Storage
The unit has been designed for stationary use only.
Any tools that are not routinely used should be stored in a dry locked room.
Assembly and Initial Operation
The unit is delivered assembled. It only needs to unpack.
•
Wipe metal parts of the slide regularly with an oil-soaked cloth and lubricate the spindle before every use.
Initial Operation Safety Instructions
•
Mind safe attachment of the unit to suitable surface.
•
Make sure that all the screws are tight.
•
Make sure all safety devices are mounted
•
Check before each start-up disc for cracks and damage
Procedure
•
Assemble individual parts in the shown order. Mind the correct arrangement of the parts according to figures.
Operation
c
b
Fig. 1
230V
50 Hz/IP 20
I
150 W/P1
-1
2800 min
125 x 30 x 10 mm
2 x 30°
30°/80°
30 mm, 28 mm, 25,4 mm, 25 mm, 20 mm 18 mm, 16 mm
1,2 m/H05 VV-F
19 kg
570 x 380 x 300
94225
Basically it is possible to sharpen saw discs of diameter
80 mm - 500 mm.
Fix the disc on the feed slide. The feed slide has three centring
holes. According to the centring hole, it is possible to mount
various diameters of saw discs.
The machine may only with the power connected, if all
adjustments are completed.
a