Operation; First Use Of Oven; Normal Use Of Oven - Franke SMART GN 42 ST XS Manuel D'installation Et Mode D'emploi

EN
Thermostat knob
Helps to set cooking temperature of the food
to be cooked in the oven. You can set
the desired temperature by turning the
knob after placing the food into the oven.
Check cooking table related to cooking
temperatures of different foods.

OPERATION

First Use of Oven
Here are the things you must do at first use
of your oven after making its necessary
connections as per instructions:
X Z
Remove labels or accessories
attached inside the oven. If any, take
out the protective folio on front side
of the appliance.
X Z
Remove dust and package residues by
wiping inside of the oven with a damp cloth.
Inside of oven must be empty. Plug the cable
of appliance into the electrical socket.
X Z
Set the thermostat knob to the highest
temperature (max. 240°C) and run
the oven for 30 minutes with its door
closed. Meanwhile a slight smoke and
smell might occur and that's a normal
situation.
X Z
Wipe inside of the oven with a slightly
warm water with detergent after
it becomes cold and then dry with a clean
cloth. Now you can use your oven.
GN 42 ST XS
Program knob
Helps to set with which heaters the food
placed in oven will be cooked. Heater program
types in this knob and their functions are
stated below. Every model might not have all
heater types and thus program types of these
heaters.
Normal Use of Oven
X Z
Adjust thermostat knob to the temperature
at which you want to cook the food to start
cooking.
X Z
You can set cooking time to any desired
time by using the knob on models with
mechanical timer. Timer will de-energize
automatically the oven when time expired
and provide warning beep as ringing.
X Z
Timer turns automatically the oven off and
provides audible signal when cooking time
expires in line with the information entered
in the models with digital timer.
X Z
Cooling system of the appliance will
continue to operate after cooking
is completed. Do not cut the power
of appliance as it requires to cool down.
System will shut down automatically after
cooling is completed.
– 10 –