Puky Skyride 20-6 Mode D'emploi page 17

bag and insert it into the right side of the rear
(B) Guide roller
(A) Konturlinie des kleinsten Ritzels
Setting the gears (model with 3-gear hub)
Installation of gear stick
Figure 10: Take the gear stick out of the poly
axle (in driving direction) until it stops at the
black spring.
Figure 11: Then you can mount the gearbox
onto the rear axle and tighten it with a 5 mm
Allen key (3-5 Nm.)
No further settings need to be made to the
gearbox.
Setting the derailleur gears
(models with derailleur gear hub)
1. Setting the limiter for the hardest gear
Rotate the upper setting screw in such a way
that, looking from the rear, the guide roller is
parallel to the contour line of the smallest gear.
(A) Contour line of the smallest gear
(C) Upper setting screw
User Manual
largest gear.
3. Setting the tension
tions by turning the tension setting screw.
(A) Größtes Ritzel
2. Setting the limiter for the easiest gear
Rotate the lower setting screw in such a way
that the guide roller is in position along the
Carry out fine adjustments of the gear posi-
Rotating anti-clockwise eases switching to the
next largest gear. Rotating clockwise eases
switching to the next smallest gear.
17
GB
(A) Largest gear
(B) Guide roller
(A) Setting screw
for tension
(C) Lower setting screw