Troubleshooting - Atag ZX6011N Mode D'emploi

IF YOU REALIZE THA T
The oven isn't heating.
"Lock" symbol flashing on and
off.
Temperature increase indicator
flashing on and off.
The light inside the oven isn't
working.
Cleaning by pyrolysis has not
occurred.
POSSIBLE CAUSES
• The oven isn't connected to the power
supply.
• The fuse has blown.
• The temperature selected is too low.
• The sensor is faulty
• The thermostat is faulty
• The oven has overheated. It has been put
out of use for safety reasons.
• The door lock is faulty.
• Request for pyro cleaning while the door
is locked.
• The temperature sensor is faulty.
• The lamp is unusable.
• The oven isn't connected to the power
supply or the fuse has blown.
• The door is not shut properly.
• The door-locking system is faulty.
• The temperature sensor is faulty.
• The plate that detects when the door is
shut is faulty.

troubleshooting

what if...
WHA T SHOULD YOU DO?
- Connect to power supply.
- Change the fuse, checking that it is 16A.
- Increase the temperature selected.
Contact the After-Sales Service.
Contact the After-Sales Service.
- Contact the After-Sales Service.
- Contact the After-Sales Service.
- Contact the After-Sales Service.
- Change the bulb.
- Connect to power supply or change
fuse.
- Check the door is properly closed.
- Contact the After-Sales Service.
- Contact the After-Sales Service.
- Contact the After-Sales Service.
99