Troubleshooting - Atag OX30 11C Mode D'emploi

IF YOU REALIZE THA T
The oven isn't heating
The light inside the oven isn't
working.
The cooling fan keeps working
after the oven is turned off.
Pyrolysing doesn't start
The door lock during pyrolysing
isn't
working.
The rotisserie spit keeps tur-
ning after the end of cooking
Smoke is being produced du-
ring cooking
There's no light inside the oven
while the pyrolysis program is ope-
rating
There's a noise inside the oven
after the end of cooking
In all cases, if you are unable to solve the problem yourself, please contact the After-Sales Service
without delay.
POSSIBLE CAUSES
The oven isn't connected to the power
supply.
The fuse has blown.
The temperature selected is too low.
Other causes.
The lamp is unusable.
The oven isn't connected to the power sup-
ply or the fuse has blown.
The fan should stop after no longer than
1 hour, as soon as the temperature of
the oven falls to approx. 125°C.
If it has not stopped after 1 hour
The door isn't shut properly.
The clock time on the programmer is flas-
hing.
Other causes.
The lock is not effective immediately
The door lock only becomes effective
approx. 2 minutes after the start of the
cycle..
The rotisserie spit motor keeps working
until the selector is returned to the zero
setting, or the door is opened, or 30 mi-
nutes after the end of the cooking
time.This program avoids the food bur-
ning once the oven has stopped four.
1.Cooking temperature too high
2. Dirty oven
The lighting is only meant to come on
for the cooking programs.
The fan in the upper part of the oven
(not visible) is working (even if the oven
is set to the "off" position).

troubleshooting

what if.....
WHA T SHOULD YOU DO?
- Connect to power supply.
- Change the fuse, checking that it is
16A.
- Contact the After-Sales Service.
- Change the bulb.
- Connect to power supply or change
fuse.
- Nothing.
- Contact the After-Sales Service.
- Make sure the door is closed correctly
- Set the hour of the day before start-
ing up the pyrolysis
- Call the After-Sales Service
If it hasn't locked after 5 minutes,
contact the After-Sales Service.
- Nothing.
1. Reduce the cooking temperature
2. Clean the oven by pyrolysis if this pro-
gram is available
The pyrolysis cycle produces temperatures,
which are too high for the lighting to work pro-
perly.
This is normal; the fan of a pyrolysis
oven st ays on until the oven has
cooled down.
GB 65