Troubleshooting; Faults Table - Atag ZX4570G Mode D'emploi

TROUBLESHOOTING

Faults table

Query
The oven is not heating.
* The padlock is fl ashing
The oven light is not working.
*The pyrolysis cleaning cycle
does not begin.
Your oven starts beeping.
The cooling fan continues to
operate after the oven stops.
When in doubt about the proper operation of your appliance, this does
not automatically mean there is a defect. Make sure to check the points
mentioned below in the table first, or visit our website 'www.atag.nl' for
more information.
If you have a doubt about the correct functioning of your oven, this
does not necessarily mean that there is a malfunction. In any event,
check the following items :
Possible causes
• The oven is not connected to
the power supply.
• Your fuse is out of order.
• The selected temperature is
too low.
• Problem with the door's locking
mechanism.
• The light is out of order.
• The door is not properly closed.
• The locking system is defective.
• During cooking.
• At the end of a cooking cycle.
• The fan should work for a
maximum of one hour after
cooking, or when the oven
temperature is greater than
125 °C.
• If it does not stop after 1 hour
Warning
Repairs to your appliance should only be made by a professional.
Non-standard repairs may be a source of danger for the user. In all
circumstances, if you cannot deal with a problem yourself, contact the
After-sales Service Department without delay.
What to do
• Plug in your oven.
• Replace the fuse in your
electrical set-up and check its
capacity (16A).
• Increase the selected
temperature.
• Call the After-Sales Service
Department.
• Call the After-Sales Service
Department.
• Check that the door is locked.
• Call the After-Sales Service
Department.
• The recommended temperature
of your choice has been
reached.
• Your programmed cooking cycle
is finished.
• Open the oven door to
accelerate the cooling down of
the oven.
• Call the After-Sales Service
Department.
EN 25