5452220-Schlagbohr_man 06.06.16 14:03 Seite 41
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This
will ensure that the safety of the
power tool is maintained.
6 Safety notes for power drills
a Wear ear protection when hammer
drilling. The effects of noise may lead
to loss of hearing.
b Use auxiliary handles supplied with
the power tool. Loss of control may
lead to injuries.
c Hold the power tool by the
insulated handle when doing work
in which it is possible that the tool
may get in contact with concealed
mains lines or its own cable.
Contact of a power tool with a mains
cable may also put its metal parts
under power and cause an electric
shock.
6 – Safety instructions
relating specifically to
the equipment
Always use goggles and
hearing protectors.
Wear a dust protection mask
• Before drilling holes in a wall, check,
if necessary using a cable detector,
whether you are at risk of contacting
concealed power, gas or water lines.
• Only change a drill/chuck when the
power tool is disconnected from
power supply (unplugged)!
• In order to prevent injuries, ensure
that the work piece to be drilled is
secured (e.g. by clamping in a vice).
• Prevent motor standstill during
operation.
Safety marks
Symbols on the power tool have the
following meaning:
Do not dispose of with the
household waste!
Important! Observe the
operating instructions!
Voluntary "geprüfte Sicher -
heit" seal of quality (tested
safety)
CE mark (conformity with
European safety standards)
The housing is double
insulated
41