Sun Function; Introduction - SOMFY HOME MOTION Sonesse 40 RTS Notice D'installation

6 Sun function

6.1 Introduction

For this function, you need a Telis Soliris
transmitter.
By default, the Sun function is not active.
1) To activate the Sun function, press the
SELECT button on the Telis Soliris transmitter
until the shade jogs.
2) To disactivate the Sun function, press the
SELECT button on the Telis Soliris transmitter
until the shade jogs.
When the intensity of the daylight exceeds the
threshold set by the Soliris sensor RTS, an order
is sent to the shade after 2 min.
The shade goes to the MY position or to
its down limit if no MY position has been
memorised.
When the intensity of the daylight falls
below the threshold set by the Soliris sensor
RTS, the shade goes to the sun disappearing
position or stays at its position (MY or Down
limit) if no sun disappearing position has been
memorised.
To set the sun diappearing position, see 6.2 part.
The Wind function is not compatible with
this motor.
8 Copyright © 2011 Somfy SAS. All rights reserved - V0 - 06/2011
1
off on
off on
off on
off on
2
OK