TOHATSU VC85BS Manuel De L'utilisateur page 22

Note 1:
When the monitor lamp does not turn on even when the lamp should be
"ON" condition (i.e. the fuel level is below one third of the tank), the bulb
should be burned out. Please replace lamp bulb or consult with your dealer.
Note 2:
When carrying out a periodical inspection and pre-operation checks, check
the monitor lamps and also each individual component.
1. (for model VC85BS)
rd
up to the 3 trial. At the 4
electric starter works.
As long as overheat cause is not remedied, lamp and buzzer keeps blink-
ing, beeping, though main switch is reset.
(Note that even if you switch the main switch to "OFF" position and, after
that, switch it back to "ON" again, lamp-blinking and buzzer-beeping re-
main active, because the engine is still under overheat condition.)
2. System does not detect such overheat as caused by shortage of engine
oil or abnormal thin gas-mixture occurred due to carburetor's malfunction.
(for model VC82ASE, VC72AS, VC52AS)
(for model VC85BS)
After overheat detected, operator can start engine
th
trial or more, engine does not start, though
Overheat
switch
- 15 -
Fuel
Engine oil
Suction
failure
6