TOHATSU VC85BS Manuel De L'utilisateur page 19

●VC85BS
Overheat
after overheat sensor works.
1. Engine restarted with main switch
kept "ON"
→Monitor lamp keeps blinking.
2. Engine restarted with main switch is renewed after switched off.
→Monitor lamp goes off (Monitor lamp is reset), but overheat buzzer
keeps beeping.
Precautions when restarting engine after engine shut-down by over-
5
heat.
1. To remedy cause of overheat
2. To restart after waiting for engine cooling down (Be sure monitor lamp
goes off).
Restarting with overheat cause is NOT remedied
1. Engine can re-start up to the 3rd trial. Engine is forced to shut down un-
less engine temperature goes down within 30seconds.
2. At the 4th trial or more, engine dose not start, though electric starter
works.
Restarting without treating cause of overheat may cause engine seizure.
Restart engine after remedy cause especially in suction line, cooling line,
fuel line and engine itself. Be sure that caution lamp and buzzer have gone
out.
monitor lamp status
CAUTION
- 12 -