Replacing The Fuse; Replacing Parts - Angelo Po FX 61 E 1-2 Manuel D'utilisation Et D'installation

RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, activate all the safety devices provid-
ed and decide whether staff at work and those in the vicinity should be informed. In
particular, turn off the water supply tap, cut off the electricity supply using the master
switch and prevent access to all devices that might cause unexpected health and safe-
ty hazards if turned on. If worn parts have to be replaced, use original spare parts only.
The manufacturer declines all responsibly for injury or damage to components due to
the use of non original parts, or extraordinary work on the appliance which may modify
the safety requirements without the manufacturer's authorisation. When ordering com-
ponents, follow the instructions provided in the parts catalogue.

REPLACING THE FUSE

To carry out this operation, proceed as follows.
1 – Undo the screws to remove the side panel (A).
2 – Open the fuse-holder (B) and replace the damaged fuse (C).
3 – Replace the fuse-holder and the side panel when the operation is complete.
IT
GB
DE
FR
ES
English

REPLACING PARTS

C
B
- 30 -
A
Use and installation manual
9
IDM-39617702200.tif