Angelo Po FX 61 E 1-2 Manuel D'utilisation Et D'installation page 52

WASHING LEVEL 1 APPLIANCE
Caution - warning
Whenever the cooking mode is changed, clean
the chamber thoroughly.
To carry out this operation, proceed as follows.
1 – In STOP status press button (20) (icon (16) lit with
a green light).
The display (7) shows the message "CLE", the dis-
play (8) the message "Pr" and the display (9) the
message "P01".
2 – When the beeper sounds (about 8 min. after
washing starts) and the "CLE" message flashes on
the display, place the detergent in the cooking cham-
ber.
3 – Open the door and spray the food-approved de-
tergent onto all the walls of the cooking chamber, the
heat exchanger and the fan.
Use of the "cleaner spray" accessory and the de-
tergent provided by the manufacturer is recom-
mended for this procedure.
Caution - warning
When cleaning and sanitising the appliance with
detergents, wear personal protection equipment
(gloves, masks, goggles, etc.) as required by the
relevant health and safety legislation.
4 – About 10 minutes after the detergent is added a
beeper will sound and the display (7) will show "H2O". At this point open the door,
rinse the cooking chamber by hand and dry it.
Use of the "washing spray gun" accessory is recommended for this procedure.
Important
Before cooking again, check that no detergent residues have been left in the
IT
cooking chamber.. If residues are found, rinse the cooking chamber thoroughly
by hand and heat the oven in "convection" mode for about 15 min. to dry it out.
GB
DE
FR
ES
English
7
16
- 18 -
8
9
20
IDM-39619500100.tif
Use and installation manual