Components; Correct Use - Meister TS800B Traduction Du Manuel D'utilisation Original

Noise/vibration information
Measured values determined in
accordance with EN62841.
- The specified noise emission val-
ues were measured in accordance
with a standardised test procedure
and can be used in order to com-
pare one power tool with another.
- They can be used to establish a
preliminary evaluation of the load.
The noise emissions generat­
ed when the power tool is
actually being used may deviate
from the specified values depend­
ing on the way in which the power
tool is used, and specifically, on
the basis of the type of workpiece
being machined.
– It is necessary to specify safety
measures for the protection of
the user which are based on the
vibration load incurred under
conditions of real use (in doing
so, all elements of the operat­
ing cycle are to be considered,
for example, times in which the
power tool is switched off, and
those in which it is switched on
but operating without load).
3 – Components
1 Saw bench
2 Groove in saw bench
3 Scale (cutting width)
4 Carriage bolt on saw blade
protector
5 Saw blade protector
6 Parallel stop
7 Locking screw for parallel stop
8 Angle scale
MW-5461570-Bedien-2003.indd 73 MW-5461570-Bedien-2003.indd 73
9 Locking handle for front saw
blade angle
10 On/off switch
11 Holder for push stick
12 Wing nut
13 Cross bar for cross-stop
14 Locking screw for cross-stop
15 Cross-stop
16 Screw and knurled screw for
cross-stop
17 Rotary knob and self-locking nut
on saw blade protector
18 Chip ejection opening
19 Saw blade cover
20 Pointer (saw blade angle)
21 Hole in machine frame
22 Locking handle for back saw
blade angle
23 Phillips screw for saw blade
cover
24 Screw for saw blade
25 Saw blade
26 Bench segment
27 Countersunk screw
28 Locking screw
29 Splitting wedge
30 L-shaped recess in splitting
wedge
31 Push stick
32 Ring spanner 19/8 mm
33 Ring spanner 10/8 mm
4 – Correct use
The circular saw bench is designed
for along-the-grain and across-the-
grain (with mitre stopper only) cut-
ting of wood of all kinds in keeping
with the size of the saw bench. It
must not be used to cut round tim-
ber of any kind. All other applica-
tions are expressly excluded. The
user/operator and not the manufac-
turer is liable for any damage or inju-
ry resulting from the improper use
of the saw. Only saw blades suita-
ble for the saw bench may be used.
73
04.05.20 16:46 04.05.20 16:46