Components; Correct Use - Meister MMF1700-1 Traduction Du Manuel D'utilisation Original

Hand/arm vibrations
a : 5,319 m/s 2
hv
Measuring inaccuracy K: 1,5 m/s
Noise/vibration information
Measured values determined
in accordance with
EN 60745-1, EN 60745-2-22.
The specified vibration emission
value was measured in accordance
with a normed test procedure and
can be used in order to compare
one electrical tool with another.
The specified vibration emission
value can also be used for an intro-
ductory evaluation of the influence.
CAUTION! The vibration emis­
sion value may fluctuate from
the specified value during use of
the power tool. These fluctuations
will depend on the way in which
the power tool is used.
Safety measures must be taken
in order to protect the operator.
As a result, the evaluation of the
influence must be made whilst
taking account of the actual con­
ditions of use. (All parts of the
operating cycle must be taken
into account for this purpose. This
also includes times in which the
power tool is switched off and
times in which it is switched on,
but is running without load.)
CAUTION! A certain amount
of noise is unavoidable when
using this device. Ensure you
carry out noise­intensive work
during permitted times. Maintain
the quiet periods and limit your
work to the absolute minimum.
5459200-Mauernutfraese_man.indd 51 5459200-Mauernutfraese_man.indd 51
CAUTION! The effects of
noise may cause damage to
the hearing. Only ever work with
2 suitable ear defenders. Anybody
else in the vicinity should thus
also wear ear defenders.
3 – Components
1 Additional handle
2 Laser marking aid
3 Protective hood
4 Setting screw for depth stop
5 Depth stop
6 Tensioning flange
7 Cutting wheel
8 Extraction duct
9 Vacuum support
10 Handle
11 On/Off switch
11a Safety switch
12 Guide roller
13 Spindle lock
14a Spacer 15,5 mm
14b Spacer 10 mm
15 Laser optic
16 Spindle
17 Tensioning flange
18 Sleeve
19 Laser On/Off switch
20 Battery compartment lid
21 2 x batteries
22 Face spanner
23 Flat chisel
24 Hexagonal wrench
25 Adapter for external dust
extractor
4 – Correct use
The wall chaser is used to cut pipe
and cable ducts in brickwork and
cement. This unit is only designed for
private use.
51
06.07.20 08:50 06.07.20 08:50