Meister TS800B Traduction Du Manuel D'utilisation Original page 90

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49
While working with the saw:
Empty the catcher bag of the chip
extractor regularly. To prevent over-
heating: do not allow chips to build
up!
After work
• Using a dry brush, clean dust and
chips from ventilation slots of the
motor housing.
• Clean dust and chips from all
guides (parallel and cross-stop).
• Clean the outside of the cas-
ing with a slightly moist cloth and
allow it to dry well.
Repair
Attempts at repair by non­ap­
proved specialists may result
in injury!
Fault tracing and repair
• The machine will not start?
– Check the power socket and
associated house fuse. Check
the supply voltage is correct
(see „Technical data").
– Have carbon brushes checked
by approved specialists.
• The motor runs irregularly,
stops, or starts with difficulty?
– Have the carbon brushes
exchanged by authorised spe-
cialists.
• The cut surfaces become dis­
coloured?
– The feed rate is too high. Saw
more sensitively and feed more
slowly!
90
– The saw teeth are blunt or bro-
MW-5461570-Bedien-2003.indd 90
MW-5461570-Bedien-2003.indd 90
ken. Replace the saw blade!
– The saw blade is gummed up.
Demount and clean saw blade!
• The cut surfaces are untidy or
tear out?
– The saw teeth are blunt or bro-
ken. Replace the saw blade!
• The workpiece jams while saw­
ing?
– Readjust riving knife!
– The parallel stop tilts or moves.
Lock parallel stop setting!
• The machine gets hot?
– Chip extractor is not working
properly.
– Chip build-up. Empty chip
extractor!
• The saw is not cutting?
– The saw blade has been fitted
the wrong way round.
• The machine is vibrating vio­
lently?
– The saw blade is out of balance.
Replace the saw blade!
CAUTION! Electrical and bat­
tery operated units that no
longer work should not be disposed
of in the household waste! They are
to be collected separately, in
accordance with the 2012/19/EU
directive
for the disposal of
electrical and electronic
waste, and sent for proper
and environ mentally­
friendly recycling.
Please discard power tools no
longer usable at a local collection
point. Collection and disposal of
packaging materials separately by
types complying with local rules
04.05.20 16:46
04.05.20 16:46

Publicité

Table des Matières
loading

Table des Matières