Operation - Meister TS800B Traduction Du Manuel D'utilisation Original

Warning! A worn or damaged
bench segment (26) must be
changed immediately.
Warning! The saw blade (25)
must be changed and aligned
properly.
7.5 Fastening on a base
• The holes (21) on the machine
frame are for fastening the device
on a firm, flat base, such as a
workbench. The appropriate fas-
tening material (screws, etc.) is
available from specialist shops.
7.6 Dust extraction
This circular saw bench is fit-
ted with a chip ejector hole
(5) and can be connected up
to a household vacuum cleaner with
a flow rate of at least 20 m/s. Follow
the manufacturer's instructions. If
necessary, use a suitable commer-
cially available adapter.
CAUTION! To prevent damage
to health from breathing in
harmful dust always use the cir­
cular saw in combination with a
working dust extractor system.
7.7 Storing loose parts
If they are not in use, the push stick
(31), parallel stop (6) and mitre stop
(15) can be fastened. The cross-
stop (15) can be fastened to the
machine housing with the wing nut
(12). The parallel stop (6) can be
stored in the machine housing.
The push stick (31) can be stored
in the holder (11) on the machine
housing.
86
MW-5461570-Bedien-2003.indd 86 MW-5461570-Bedien-2003.indd 86
8 – Operation
• After each new adjustment, we
recommended making a sample
cut to check the set size.
• After switching the saw on, wait
for the saw blade to reach its
maximum rotation speed before
making the cut.
• Be careful when up-cutting!
• Only operate the device with
extraction.
• Check and clean the extraction
channels regularly.
Before starting the saw up
• The saw bench must be set up
on a stable base, that is, a work-
bench, or screwed down to a firm
underframe.
• Before starting up all covers and
safety equipment must be correctly
fitted.
• The saw blade must be able to
rotate freely.
• When working with wood which
has already been processed, be
careful of e.g. nails or screws,
cracks or joints, etc.
• Before you press the On/Off
switch (10), make sure that the
saw blade is correctly mount-
ed and moving parts are running
smoothly.
• Before connecting up the saw
bench to the mains make sure that
the data on the rating plate match
those of the mains supply.
04.05.20 16:46 04.05.20 16:46