Components; Application - Meister TS800M Traduction Du Manuel D'utilisation Original

5461560-Tischkreiss_man 22.08.18 14:13 Seite 43
with another. The specified vibration
emission value can also be used for an
introductory evaluation of the influence.
CAUTION! The vibration
emission value may fluctuate
from the specified value during use of
the electrical tool. These fluctuations
will depend on the way in which the
tool is used.
Try to keep the vibration loads as low
as possible. Examples of measures
that may be taken to reduce the
vibration load include wearing gloves
when using the tool and limiting the
length of the working period. All parts
of the operating cycle must be taken
into account for this purpose (for
example, also including times in
which the power tool is switched off
and times in which it is switched on,
but is running without load).
3 – Components
1 Safety hood
2 Screw
3 Saw bench
4 Scale
5 Chip ejector
6 Frame
7 Safetycover
8 Angular mark
9 Knurled screw
10 On/Off switch
11 Knurled screw
12 Fixing rail
13 Parallel stop
14 Splitting wedge
15 Saw blade
16 Mitre stopper
17 Motor
18 Pushing stick
19 Wrenches
20 Bench liner
4 – Correct use
The circular saw bench is designed for
along-the-grain and across-the-grain
(with mitre stopper only) cutting of wood
of all kinds in keeping with the size of
the saw bench. It must not be used to
cut round timber of any kind. All other
applications are expressly excluded. The
user/operator and not the manufacturer is
liable for any damage or injury resulting
from the improper use of the saw. Only
saw blades suitable for the saw bench
may be used. The use of cutting-off
wheels of any kind is prohibited. Proper
use also includes adherence to the safety
instructions and the hints for operation
in the operating instructions. Persons
using and servicing the saw bench
must familiarize themselves with these
instructions and be aware of any possible
hazards. Any changes made to the saw
bench will wholly invalidate the
manufacturer's liability for loss or damage
arising from its use and will result in a
lapse of the guarantee. Even in the case
of proper use certain residual risk factors
due to the saw bench design cannot be
completely precluded:
• Contact with the saw blade at those
points where it is not covered.
• Contact with the edge of the rotating
saw blade, resulting in cut injuries.
• Knock-back of workpieces and parts
of workpieces through incorrect
handling.
• Breakage of saw blades.
• Flying off of defective hard-metal parts
of the saw blade.
• Damage to hearing through failure to
use the necessary ear protectors.
43