Mode Of Operation - Meister TS800B Traduction Du Manuel D'utilisation Original

• Check the distance between the
stop bar (13) and saw blade (25).
Warning! Do not slide the
stop bar (13) too close to the
saw blade (25). The distance
between the stop bar (13) and the
saw blade (25) should be approx.
2 cm.
• If necessary, loosen the screw
and knurled screw (16) and adjust
the stop bar (13).
• Re-tighten screw and knurled
screw (16).
8.4 Angle setting
• Loosen the locking handle (9) at
the front and the locking handle
(22) at the back of the machine.
• Adjust the saw blade angle by
sliding both locking handles (9,
22) until the pointer (20) corre-
sponds to the desired angle size
on the angle scale (8).
• Lock the locking handles (9, 22).
9 – Mode of operation
Working with the circular bench
saw
9.1 Making longitudinal cuts
(Fig. 7)
This is when a workpiece is cut
through along its length.
One edge of the workpiece is pressed
against the parallel stop (6), while the
flat side lies on the saw bench (1).
88
MW-5461570-Bedien-2003.indd 88 MW-5461570-Bedien-2003.indd 88
The saw blade protection (5) must
always be lowered onto the work-
piece.
The work setting for longitudinal
cuts must never be in line with the
course of the cut.
• Set parallel stop (6) in accordance
with the workpiece height and
desired width.
• Switch on the saw.
• Place your hands flat on the
workpiece with your fingers
closed and slide the workpiece
along the parallel stop (6) into the
saw blade (25).
• Only guide from the side with
your left or right hand (depend-
ing on the position of the parallel
stop) as far as the front edge of
the protective hood.
• Always slide the workpiece to the
end of the splitting wedge (29).
• Waste cuttings stay on the saw
bench (1) until the saw blade (25)
is back in its resting position.
• Secure long workpieces against
pitching at the end of cutting!
(e.g. unwind frames etc.)
9.1.1 Cutting narrow workpieces
(Fig. 11)
Longitudinal cuts of workpieces with
a width of less than 150 mm must
always be made with the help of a
push stick (31). The push stick is
included in the scope of delivery.
Change worn-out and/or damaged
push sticks immediately.
04.05.20 16:46 04.05.20 16:46